6 years in since ford switched to the oil pump belt design and i haven't seen a single failure on any v6 ecoboosts or the 5.0, so i don't think there is too much to worry about. I believe the ranger was the first 2.3 released to use this type of pump The common causes of cam phaser failure in the ford bronco raptor include design defects and manufacturing issues, leading to oil leakage and wear on the cam phasers, resulting in a.
Ford Ecoboost 3.5 VCT Phaser Cold start rattle replacement Gen2 Part 2
Has anyone experienced this on the bronco raptor
The last two days when i have cold started the first 5 seconds has a nasty, loud rattle
Before i start digging into this i was wondering if anyone had a similar ticking/knocking noise when cold starting It happens most the time on cold starts after sitting overnight and sometimes. I have a similar noise that sounds like it's coming from the passenger footwell area Goes away after a few seconds and like you, only happens when i first start it and then not all the time.
A bad cam phaser can produce a rattling or knocking noise from the engine, especially at idle or low speeds This noise may be more pronounced when the engine is cold and can indicate that. In this thread below is a couple short video's of the cam phaser rattle The last two days when i have cold started the first 5 seconds.
This noise usually comes from the top or side of the engine.
Probably the phaser locking lock wearing Plan to fix within 6 to 12 months. I have been experiencing the cold start rattle as well Took it into the dealership and they just got word from ford that they need to replace all 4 variable camshaft timing units (cam phasers).
No performance or drivability issues If you're getting start up sound, and its due to air in the lash adjusters or cam phasers, then changing oils or throwing snake oil at it isn't going to help 2.7s and 3.5s all have the same problem The new updated 2.3 in the mustang uses the same style now also
