$150 and i drive my car hard and drift it often. I’m having trouble getting my cv axle in on the transmission side and people seem to recommend using grease to center the c clip I accidentally tap the side of rear (cv) axle which connects to diff
ECS News - BMW E46 325xi/330xi Axle Shafts Replacements
Should i replace it or it is good to go?
Hitting the wheel bearings might not be the best idea but i have not had any issues.
To make your axles as strong as possible, especially if your car is lowered, we recommend using our axles spacers If you want to go the next step. Planning on give the complete rear axle on my e46 m3 a bit of an overhaul when my subframe is being reinforced and i'm looking for some advice on bushes/components for the rebuild. Adhere to the following installation sequence in order to prevent distortion of the rear axle final drive during installation and thereby avoid potential complaints about noise
Insert the rear axle differential. For those that don't know, the rear axle carrier is often called the rear subframe 1) unbolt everything attached to and near the rear subframe 2) unbolt and remove the subframe 3) to install,. Hey guys and gals, can anyone tell me if i buy an entire assy
Of the right rear half axle is the job easy enough for an amateur like me to do the job??
Looks like 6 bolts at wheel and slide out of. I’m going though a big maintenance job replacing all of my wheel bearings What is the consensus on rear axle maintenance I have a ~160k mikes on them
Do i need to consider a rebuild or. Am i looking at new set of axles or could there be a problem i'm missing somewhere? A few ways to tell a joint in your cv axle may be going bad even if the axle looks alright externally Bottom line, it needs to be lubricated, sealed from th.
Do you do this on transmission side
