Could also be a bad ground Each diagram and illustration are from the original ford motor company publication and are the same manuals used by ford technicians to troubleshoot electrical and vacuum repairs. A corroded connection, or corroded wire will show voltage but not handle loads
1996 Ford Bronco Electrical and Vacuum Troubleshooting - Fordmanuals.com
Also as the bad/weak connection.
Replaced all three oxygen sensors and took off positive batt
Now with all lights off, when i open either door the. Found the break in the line, it had cracked insulation on it as well as the black/blue line and it had melted a little bit around the two spots that i assume touched Anyways, it’s fixed now and i’m. I tried to hunt one up awhile ago and was told not available from ford
I would call the local international dealer and try them They make the harness for the engine. Have i ever mentioned that i'm not an electrician and wiring is not my thing Because i always seem to end up being the one wiring some stuff lol.join this c.
I’ll look again to make sure i didn’t miss something there.
